Sensors

ntz310n-ph

NTZ-310N-PH    pH Sensor

The pH electrode is for measuring the pH level on an aquarium in continuous immersion. It must be connected to power units through the appropriate interface. Thanks to our  systems flexibility, it is possible to simultaneously connect and monitor several electrodes and interfaces of the same type.

Technical specifications
MEASURING RANGE from 0 to 14 pH
MATERIAL single joint combined electrode with plastic casing
ntz310n-o2

NTZ-310N-O2    Oxygen Polarographic Probe

Dissolved Oxygen Probe is used to measure and control the value of dissolved oxygen  in water (O2);   This value can be displayed as % of saturation or as ppm.

Technical specifications
MEASURING RANGE 0-15 ppm / 0-120%
TEMPERATURE SENSOR PT100
KIND OF SENSOR Pholarographic
ntz310n-fw-1_2

NTZ310-FW-1/2  Flow meter sensor

Technical specifications
POWER SUPPLY 12 VDC
OUTPUT SIGNAL Amplified Square Wave
ntz310n-rx

NTZ-310N-RX    Redox Sensor

The Redox electrode (ORP) is for measuring the ORP value  continuous immersion. It must be connected to the power unit through the dedicated interface. Thanks to our  systems flexibility, it is possible to simultaneously connect and monitor several electrodes and interfaces of the same type.

Technical specifications
MEASURING RANGE from – 0mV to 1400mV
MATERIAL single joint combined electrode with plastic casing
ntz310n-ec

NTZ-310N-EC   EC Electrode

The EC electrode is used to measure the Conductivity value  in continuous immersion in water. This value can be displayed as Conductivity. It must be connected to the power unit through the dedicated interface.

Technical specifications
MEASURING RANGE from 0 mS to 15 mS
MATERIAL Plastic sensor with 2 graphite electrodes
This site uses cookies. It also uses third party cookies, for analytical purposes. To learn more or to deny access to all or to some cookies, click here.